Skip to main content
本页暂无Chinese版本，以下为英文原文。 查看英文版 →
P0102 P0xxx · 动力总成（P） 中严重度

Mass Air Flow Circuit Low Input

The MAF signal stays below the plausible minimum. The ECU falls back to a speed-density calculation, which keeps the car drivable but with compromised mixture control.

严重程度说明： 中——已影响行驶或排放，请本周内安排检修

你会注意到的故障现象

  • Hard starting
  • Stalling
  • Limp mode
  • Very poor fuel economy

常见原因

按可能性从高到低排列——从最上面开始查。

  1. 1 Open signal wire or connector
  2. 2 Failed MAF sensor
  3. 3 Blown sensor supply fuse
  4. 4 Water ingress in the connector

如何排查

先做花钱最少、侵入最小的检查——大多数这类码不是零件问题。

  1. ✓ Check for 12 V supply and good earth at the sensor connector.
  2. ✓ Back-probe the signal wire; it should vary smoothly with throttle.
  3. ✓ Wiggle the harness while watching the PID to find an intermittent break.
  4. ✓ Compare MAF reading against the calculated load PID.

维修方案

  • Replace the MAF sensor
  • Repair the harness or connector
  • Replace the supply fuse

P0102 —— 常见问题

Will the car still run? +

Yes, in a fallback mode using RPM and throttle as a substitute — drivable but not right.

Is unplugging the MAF a valid test? +

It proves the ECU's fallback works, but it does not prove the sensor is good. Measure the signal instead.

买配件之前先确认诊断结论

把故障码、冻结帧数据和车型发给我们——工程师会告诉你先测哪一项。

获取免费报价 浏览产品